P2475 - Pipe Roller for 6" thru 16" Pipe
Part No. | Finish | Product Weight / Piece (lbs) |
---|---|---|
P2475 | EG | 6.8 |
P2475 | HG | 6.85 |
P2475 | GR | 6.8 |
Design Loads
Design Load = 1,500 lbs
Notes:
- Design loads only apply to Unistrut brand products. Look for "UNISTRUT" on the part.
- Safety factor = 2.5 based on the ultimate strength of the connection when mounted to 12 gauge channel.
- Requires 2 each 1/2" Channel Nuts and Bolts (not included).
- Sold in pairs.
Dimensions
Pipe & Conduit Reference Data
General Specifications
Standard Dimensions (Unless Shown Otherwise on Drawing):
- Hole Diameter: 9/16" (14mm)
- Hole Spacing (From End): 13/16" (21mm)
- Hole Spacing (On-Center): 1 7/8" (48mm)
- Width: 1 5/8" (41mm)
- Thickness:
- 1/4" (6.4mm) with steel meeting or exceeding ASTM A1011 SS GR 33, or
- 0.220" (5.6mm) with steel meeting or exceeding ASTM A1011 HSLAS GR 45
Note:
- When used for mechanical supports, load capacities of brackets and fittings should be in compliance with the American Standard Code for Pressure Piping.
Installation:
- Torque:
Note: When tightening 1/4" screws used with a two piece pipe clamp, a torque of 5 ft-lbs (60 in-lbs) should be used.
Materials & Finishes
Materials & Finishes
- Base Metal: Steel conforms to ASTM A1011 SS GR 33, A1011 HSLAS GR 45, A36, A575, A576, or A635.
- Rollers: Cast Iron
- Electrogalvanized (EG): Conforms to ASTM B633, Type III SC1
- Hot Dip Galvanized (HG): Conforms to ASTM A123 or A153
- Perma-Green (GR): Conforms to commercial standards for powder coating