P1354A - Adjustable 3-Hole Hinge

P1354A-No-Dimensions.png
Add to Project Download
Resources
Download
Cut Sheet
Part No. Finish Product Weight / Piece (lbs)
P1354A EG 0.89
P1354A GR 1.09
P1354AW EG 1.09

    Design Loads



    Notes:
    1. Design loads only apply to UNISTRUT brand products. Look for "UNISTRUT" on the part.
    2. Design loads are based on static testing with a Safety Factor = 3.0 to the ultimate strength of connection.
    3. 1/2" Unistrut Channel Nut and Cap Screw torqued to 50 ft-lbs required for installation.
    4. Some design loads limited to 1,500 lbs for Slip Load of Channel Nuts.
    5. The "W" in the part number designates that the hinge has welds to increase strength.

    Seismic Design Loads


    Notes:
    1. Seismic Design Loads only apply to UNISTRUT brand products. Look for "UNISTRUT" on the part.
    2. Seismic Design Loads are based on FM1950-10 dynamic testing with 12 ga. channel and a safety factor of 1.5.
    3. 1/2" Unistrut Channel Nut and Cap Screw torqued to 50 ft-lbs required for installation.
    4. Seismic Design Loads apply only to the P1354AW EG fitting. The "W" in the part number designates that the hinge has welds to increase strength.
    5. Reference page 5c.1 of Unistrut OPM-0295-13.

    General Specifications

    Standard Dimensions (Unless Shown Otherwise on Drawing):

    • Hole Diameter:  9/16"  (14mm)
    • Hole Spacing (From End):  13/16"  (21mm)
    • Hole Spacing (On-Center):  1 7/8"  (48mm)
    • Width:  1 5/8"  (41mm)
    • Thickness:
    • 1/4"  (6.4mm) with steel meeting or exceeding ASTM A1011 SS GR 33, or
    • 0.220" (5.6mm) with steel meeting or exceeding ASTM A1011 HSLAS GR 45

    Note:

    • When used for mechanical supports, load capacities of brackets and fittings should be in compliance with the American Standard Code for Pressure Piping.

    Materials & Finishes

    Materials & Finishes - Standard:

    • Base Metal: Steel conforms to ASTM A1011 SS GR 33, A1011 HSLAS GR 45, A36, A575, A576, or A635.
    • Electrogalvanized (EG):  Conforms to ASTM B633, Type III SC1
    • Unistrut Defender (DF):  Conforms to ASTM A1059
    • Hot Dip Galvanized (HG):  Conforms to ASTM A123 or A153
    • Perma-Green (GR):  Conforms to commercial standards for powder coating
    • Perma-Gold (ZD):  Conforms to ASTM B633, Type II SC1
    • Plain (PL):  No finish 

    Materials & Finishes - Special Metals:

    • Stainless Steel, Type 304 (SS):  Conforms to ASTM A240 or A276, Type 304 *
    • Stainless Steel, Type 316 (ST):  Conforms to ASTM A240 or A276, Type 316 *
    • Aluminum (AL):  Conforms to ASTM B209, Type 1100F or 5052-H32 *

    * These materials have different physical properties and performance characteristics. Please contact us for design support.